Airsoft Systems makes one of the best airsoft MOSFET triggers, and pioneered the AEG drop in replacement MOSFET. The ASCU V3 MOSFET (17535) replaces the basic trigger mechansim with a direct-interface circuit control board with integrated MOSFETs. This Programmable Airsoft Trigger features 7 firing modes, including burst modes, as well as provides increased reliability with full compression stroke completion and emergency stop if the gearbox fails to cycle.
The ASCU Version 3 is a dual board assembly with pre-installed wiring so you don't have to solder any wires. An AK and G36 selector plate are included to guarantee correct engagement on the switch, and a cutoff lever and Sector Gear Chip are included.
The Gen3+ monitors AEG operation, and ensures a full cycle even if you tap the trigger, or release the trigger during the middle of a cycle in full or semi auto. It also features built in lipo low voltage monitoring, protecting your batteries from over discharge.
ASCU Version 3 Programmable Drop In Trigger MOSFET Gen 3+ Features:
-Always Completes Full Cycle
-No Gearbox Lockup
-Crisp and Realistic Trigger Feel
-Reduced Trigger Travel
-Faster Trigger Response
-Improved Battery Life
-Increased Spring Life
-7 Selectable Firing Modes
-Compatible with All Batteries, Motors, Spring Rates
-Integrated Lipo Drain Protection